HomeProductsLaser DriversPLD-PS-SYNC short pulse laser diode driver

PLD-PS-SYNC short pulse laser diode driver

Key features

  • Special Design for 10/14 pin Butterfly Laser Diode
  • Output current up to 2000 mA
  • Compliance voltage up to 3 V
  • Extra short 50 ps pulse width
  • Repetition rate up to 30 MHz
  • External trigger option
  • External clock option
  • Master/slave operation mode with the repetition rate jitter suppression
  • USB, RS-232, CAN, UART interfaces
  • On-Board TEC Controller
  • 5Vdc Input Power
  • Completed by Heatsink
  • Compact Size 85 mm ×60 mm ×21 mm


The PLD-PS-SYNC is a compact short-pulse seed laser diode driver for powering 10/14-pin butterfly laser diode modules for applications, which require pulse widths about 50 ps. The pulse repetition frequency can be varied from 1 kHz to 30 MHz.

The driver is specially designed to minimize jitter between external trigger signal and optical pulse by enabling external clock synchronization. The driver also supports operation in Master/Slave mode and synchronization of optical pulses between two lasers, one operates as Master and another one as Slave, with the optical pulse position jitter below 500 ps and tunable delay between the optical pulses from two lasers.

The driver circuitry requires a single 5 VDC power source. All other needed voltages are generated on the board by high-frequency switching power supplies. The driver supplies a bidirectional proportional-integral-derivative (PID) thermoelectric cooler controller (TEC) with current capability of 1.5 A and a voltage capability of 4 V.

The main parameters of PLD-PS-SYNC (power, repetition frequency, temperature set point, pulse delays in sync mode) are controlled by computer interface.

The PLD-PS-SYNC has an external TTL-compatible input for repetition rate control from single shot up to 30 MH. The driver has an external output for synchronization with each current pulse. The PLD-PS-SYNC has an external input/output of the clock frequency for synchronous operation of two drivers with minimal period jitter between optical pulses.

Driver has landing pads for soldering a butterfly laser diode directly into driver board and large heat sink for stable heat dissipation.



External trigger (50 Ω impedance)VDC3,35
Compliance VoltageV13
Pulse width*ps4050150
Repetition rateMHz0,00130
Rise time*ps405060
Fall time*ps4050100
TEC currentA-1,5+1,5
TEC voltageV14
TEC Temperature Set˚C152550
Repetition rate in sync modeMHz1
Pulse delay in sync modens-50+50
Humidity, Non-Condensing%95
Power and inteface connectorTerminal block (1-282834-0 TE connectivity)
USBMini-USB, Type B (1734035-1 TE connectivity)
External trig in/outSMA (1-1478979-0 TE connectivity)
Clock in/outU.FL (U.FL-R-SMT-1(10) Hirose Electric)
Size85 × 60 × 21 mm
Weight, not more160 g

* Output performance depends on laser diode characteristics. Performance cannot be guaranteed for all laser types.
See optical output waveforms.

Typical performance characteristics

Typical pulse form and dependence of average power on operation voltage for different types of laser diode.
a) DFB 1064 nm, b) FBG 1550 nm, c) FBG 1064 nm, d) FP 1030 nm